Lift Loading Rubber Ramps

Vehicle Lift Loading Ramps - Rubber Ramps - Extension Ramps

Cars with a very low chassis, low ride height cars or short wheel base cars often do not have enough space to drive on or over a vehicle lift; whether it be 1 post lift, 2 post lift, 4 post lift, scissor lift or parking lifts. At Equipment4garages we have found a solution using heavy duty and heavy weight rubber granulate ramps that overcomes the decades old problem. Workshops used to sink lifts into the ground to make it easier to load or have strategically placed scaffold boards to increase the car height enabling the lift to be used. Now it is not needed. Instead you can purchase ramps in 3 different heights special designed to overcome the problem.

Workshops used to sink lifts into the ground to make it easier to load orhave strategically placed scaffold boards to increase the car height enabling the lift to be used. Now it is not needed.

Car loading problem with 4 post lifts:
The run up was not long enough to prevent the car from grounding on the approach ramps

Solution:
Place run up ramps at the front 

Car loading problem with 2 post lifts:
Cars too low to allow the lift pads and arms to be swung underneath

Solution:
Place rubber ramps at the front and the rear of the car

Car loading problem with scissor lifts:
Unable to get over the car onto the scissor lift or if been able to get onto the scissor lift, unable to insert rubber blocks to prevent damage to the underside of the car

Solution:
Place rubber run up ramps at the front and rear of the scissor lift

Part numbers and dimensions:

E4G 284 Rubber Ramp Mat 1000 x 500 x 30mm

E4G 285 Rubber Ramp Mat 1000 x 500 x 40mm

E4G 286 Rubber Ramp Mat 1000 x 500 x 50mm

Note: To prevent damage in transit these rubber ramps are place on specially designed wooden pallets and they can be used for storage of the ramps when not in use.